selection circuit

This paper discusses the relationship of the circuit structure of dynamic circuit and the ordering of differential equation, effect of selection unknown variables on the solution of equation and the calculations of special solution and initial values.

分析了电路结构与微分方程阶次的关系，电路未知变量的选择对求解方程的影响，特解和初始值的计算方法。

The Selection of Thermistance Parameters Upon the Sensitivity of Bridge Temperature Control Circuit

桥式温控电路中热敏电阻参数的选择

Complete the experiment study of the design, especially analyze the selection of device, circuit design emulation, module circuit debugging and associated debugging for whole system.

完成设计方案的实验研究。特别对试验中的器件选择、电路设计仿真、单元电路调试、整个系统联调及其问题进行分析探讨。

Test Point Selection for Analog Integrated Circuit

模拟集成电路的测试节点选择

The right selection of independent cycle circuit in the calculation of Kirchhoff law is studied. Two methods, namely, the method of single chain cycle circuit and the method of plane net hole are given.

分析了两种选择独立回路的错误作法，给出了两种正确选择独立回路的方法，即单链回路法和平面网孔法。

Influence of Circuit Performance on Selection of Working Wavelengths in Infrared Thermometry System

红外测温系统中电路性能对工作波长选择的影响

Standard on Selection, Care, and Maintenance of Open-CircuIt'sCBASCEA.

建筑灭火整体保护的选择 、 注意及保养标准.

Effective solutions are proposed for the selection of independent circuit, calculation of density for varying water temperature, calculation of thermal pressure and simulation of pump characteristic curve in numerical simulation of pipe networks.

对管网数值仿真中独立回路的选择、水温变化时密度的计算、热压的计算、水泵特性曲线的模拟等均提出了有效的解决方法。

Chapter 4 describes the theory of interpolating circuit that uses analog circuit to turn error pulses to voltage. The design of interpolating circuit and devices selection is introduced in this section too.

第四章阐述了利用模拟电路将误差脉冲转化为电压量的内插电路原理，论述了电路的设计及器件参数的选择。

It can be placed in a selection of locations but it will always be found somewhere in the high pressure part of the circuit in between the compressor output and the thermal expansion valve.

它可以被安装在几个位置上，但这些位置仅限于线路的高压侧，且在压缩机输出端和热力膨胀阀之间。